Click here

STEERING ANGLE SENSOR REMOVAL

Click here
Click here Click here
  1. Click here

    PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE STEERING WHEEL ASSEMBLY


    1. (Click here)

  4. Click here

    REMOVE STEERING COLUMN COVER


    1. for Manual Tilt and Manual Telescopic Steering Column:

      (Click here)

    2. for Power Tilt and Power Telescopic Steering Column:

      (Click here)

  5. Click here

    REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR

    (Click here)

    Note:

    • Do not replace the spiral cable with the battery connected and the ignition switch ON.

    • Do not rotate the spiral cable with the battery connected and the ignition switch ON.

    • Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

    • Do not remove the steering angle sensor from the spiral cable.