VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster) PROBLEM SYMPTOMS TABLE
Tech Tips
-
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
-
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Note
When replacing the brake actuator assembly, sensor, etc., turn the ignition switch off.
| Symptom | Suspected Area | See page |
|---|---|---|
| ABS, BA and/or EBD does not operate | Check for DTCs again and make sure that normal system code is output | |
| IG power source circuit (low power supply voltage malfunction) | ||
| IG power source circuit (high power supply voltage malfunction) | ||
| Front speed sensor circuit (comparison malfunction) | ||
| Front speed sensor circuit (open or short malfunction) | ||
| Front speed sensor circuit (output malfunction) | ||
| Rear speed sensor circuit (comparison malfunction) | ||
| Rear speed sensor circuit (open or short malfunction) | ||
| Rear speed sensor circuit (output malfunction) | ||
| Check brake actuator assembly with intelligent tester (check brake actuator assembly operation using Active Test function). If abnormal, check hydraulic circuit for leaks. | ||
| If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU) | ||
| ABS, BA and/or EBD does not operate efficiently | Check for DTCs again and make sure that normal system code is output | |
| Front speed sensor circuit (comparison malfunction) | ||
| Front speed sensor circuit (open or short malfunction) | ||
| Front speed sensor circuit (output malfunction) | ||
| Rear speed sensor circuit (comparison malfunction) | ||
| Rear speed sensor circuit (open or short malfunction) | ||
| Rear speed sensor circuit (output malfunction) | ||
| Stop light switch circuit | ||
| Check brake actuator assembly with the intelligent tester (check brake actuator assembly operation using Active Test function). If abnormal, check hydraulic circuit for leaks. | ||
| If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU) | ||
| ABS warning light abnormal (Remains on) | ABS warning light circuit | |
| IG power source circuit (High power supply voltage malfunction) | ||
| Brake actuator assembly (skid control ECU) | ||
| ABS warning light abnormal (Does not come on) | ABS warning light circuit | |
| Brake actuator assembly (skid control ECU) | ||
| Brake warning light abnormal (Remains on) | Brake warning light circuit | |
| IG power source circuit (High power supply voltage malfunction) | ||
| Brake actuator assembly (skid control ECU) | ||
| Brake warning light abnormal (Does not come on) | Brake warning light circuit | |
| Brake actuator assembly (skid control ECU) | ||
| VSC and/or TRC does not operate | Check for DTCs again and make sure that normal system code is output | |
| IG power source circuit (low power supply voltage malfunction) | ||
| IG power source circuit (high power supply voltage malfunction) | ||
| Check hydraulic circuit for leaks | - | |
| Front speed sensor circuit (comparison malfunction) | ||
| Front speed sensor circuit (open or short malfunction) | ||
| Front speed sensor circuit (output malfunction) | ||
| Rear speed sensor circuit (comparison malfunction) | ||
| Rear speed sensor circuit (open or short malfunction) | ||
| Rear speed sensor circuit (output malfunction) | ||
| Yaw rate and acceleration sensor circuit (zero point malfunction) | ||
| Yaw rate and acceleration sensor circuit (power supply malfunction) | ||
| Acceleration sensor circuit (comparison malfunction) | ||
| Yaw rate sensor circuit (comparison malfunction) | ||
| Yaw rate and acceleration sensor circuit (stuck or output malfunction) | ||
| Yaw rate and acceleration sensor circuit (internal malfunction) | ||
| Steering angle sensor circuit (zero point malfunction) | ||
| Steering angle sensor circuit (power supply malfunction) | ||
| Steering angle sensor circuit (output malfunction) | ||
| Steering angle sensor circuit (internal malfunction) | ||
| If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU) | ||
| VSC OFF indicator abnormal (Remains on) | VSC OFF indicator light circuit | |
| Brake actuator assembly (skid control ECU) | ||
| VSC OFF indicator abnormal (Does not come on) | VSC OFF indicator light circuit | |
| Brake actuator assembly (skid control ECU) | ||
| Slip indicator light abnormal (Remains on) | Slip indicator light circuit | |
| IG power source circuit (High power supply voltage malfunction) | ||
| Brake actuator assembly (skid control ECU) | ||
| Slip indicator light abnormal (Does not come on) | Slip indicator light circuit | |
| Brake actuator assembly (skid control ECU) | ||
| TRC OFF indicator light abnormal (Remains on) | TRC OFF indicator light circuit | |
| Brake actuator assembly (skid control ECU) | ||
| TRC OFF indicator light abnormal (Does not come on) | TRC OFF indicator light circuit | |
| Brake actuator assembly (skid control ECU) | ||
| DTC check cannot be performed | Check for DTCs again and make sure that normal system code is output | |
| TC and CG terminal circuit | ||
| IG power source circuit (high power supply voltage malfunction) | ||
| If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU) | ||
| Sensor check cannot be performed | TS and CG terminal circuit | |
| Brake actuator assembly (skid control ECU) | ||
| Buzzer abnormal | VSC buzzer circuit |