REAR UPPER ARM REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE REAR WHEEL

  2. DISCONNECT REAR HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY (w/ Air Suspension)


    1. A01DPDW

      Disconnect the connector, and then detach the connector.

    2. Detach the clamp.

    3. A01DS2PE01
      Text in Illustration
      *1 Matchmark

      Place matchmarks on the link and bracket.

    4. Remove the nut and disconnect the sensor link.

    5. Remove the 2 bolts and height control sensor.

      Note

      Replace the rear height control sensor sub-assembly with a new one if it is dropped.

  3. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH


    1. A01DTGS

      Remove the nut, washer and bolt from the rear axle housing.

      Tech Tips

      Turn the nut while holding the bolt.

    2. A01DTBU

      Remove the nut, washer, bolt and upper control arm assembly.

      Tech Tips

      Turn the nut while holding the bolt.