Click here

TIRE PRESSURE WARNING SYSTEM Tire Pressure Warning Light Circuit

Click here
Click here Click here
DTC Code DTC Name
  Tire Pressure Warning Light Circuit
Click here

DESCRIPTION

If the tire pressure warning ECU and receiver detects a disconnected connector or an open circuit between the tire pressure warning ECU and receiver and combination meter assembly, the tire pressure warning light blinks for 1 minute, and then remains on after the ignition switch ON.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

  • When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

  • It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECU)


    1. Disconnect the tire pressure warning ECU and receiver R41 connector.

    2. Disconnect the combination meter assembly G7 connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      R41-5 (IND) - G7-16 (TIRE) Always Below 1 Ω
      R41-5 (IND) or G7-16 (TIRE) - Body ground Always 10 kΩ or higher

  2. Click here

    CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST)


    1. Turn the ignition switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the ignition switch ON.

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    6. Check the condition of the tire pressure warning light by using the GTS.

      Table 1. Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Indicat. Tire Pressure Warning System Tire pressure warning light OFF or ON Confirm that the vehicle is stopped with the engine idling.
      OK
      The tire pressure warning light turns on or off in accordance with the GTS operation.

  3. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  4. Click here

    GO TO METER / GAUGE SYSTEMClick here

  5. Click here

    REPLACE TIRE PRESSURE WARNING ECU AND RECEIVERClick here