FRONT SHOCK ABSORBER REASSEMBLY

INSTALL FRONT SHOCK ABSORBER BUSH
1. Using SST and a press, install a new absorber bush.
  
  SST
  
  09710-30012 ( 09710-04071, 09710-04081 )
INSTALL FRONT COIL SPRING LH
1. Secure SST in a vise.
  
  SST
  
  09727-30022 ( 09727-00010, 09727-00031 )
  
  09727-00060
2. Text in Illustration
  
  *a Correct
  
  *b Incorrect
  
  Attach the arm of SST to the diameter of the coil spring.
  CAUTION:
  
  Make sure that the coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
  
  Make sure that the claws of the hooks are securely attached.
3. Using SST, compress the coil spring.
  CAUTION:
  - If the coil spring bends during the compression, immediately stop the compression and reinstall SST.
  - Do not compress the spring until the coil springs contact each other.
  - Do not use an impact wrench.
4. Text in Illustration
  
  *a Lower End
  
  Install the coil spring to the shock absorber.
  
  Tech Tips
  
  Fit the lower end of the coil spring into the recess of the spring seat of the shock absorber.

INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH

Install the cushion, 2 retainers and suspension support to the piston rod.
Temporarily install a new front shock absorber nut to the suspension support.

A01DOO3E01

Text in Illustration
*A	LH
*B	RH
*1	Absorber Bush
*2	Suspension Support Sub-assembly
	Front

Position the suspension support as shown in the illustration.

Remove SST.

Tech Tips

Release the coil spring while checking the position of the suspension support.

Note

Do not use an impact wrench. It will damage the shock absorber rod.

TIGHTEN FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
1. Tighten a new nut.
  
  Torque:
  
  25 N*m { 255 kgf*cm, 18 ft.*lbf }