HEIGHT CONTROL COMPRESSOR INSTALLATION


  1. INSTALL HEIGHT CONTROL COMPRESSOR BRACKET


    1. Install the height control compressor bracket with the 3 bolts.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

  2. INSTALL HEIGHT CONTROL COMPRESSOR ASSEMBLY


    1. Install the 3 bushes to the height control compressor.

    2. Install a new O-ring.

    3. Install the height control dryer with the bolt

      Torque:
      6.4 N*m  { 65 kgf*cm, 57 in.*lbf }

    4. Install the height control compressor to the bracket with the 3 bolts.

      Torque:
      5.9 N*m  { 60 kgf*cm, 52 in.*lbf }

    5. Connect the connector.

    6. Attach the clamp.

    7. Attach the 3 clamps.

    8. Connect the connector.

    9. Attach the No. 2 height control tube.

  3. CONNECT NO. 2 HEIGHT CONTROL TUBE


    1. A01DLZ6

      Connect the No. 2 height control tube Click here.

      Tech Tips

      For the connection procedure of the tube (type 2), refer to Precaution of the Suspension Control System section.

  4. INSTALL HEIGHT CONTROL FILTER


    1. Install the height control filter with the 2 bolts.

      Torque:
      6.4 N*m  { 65 kgf*cm, 57 in.*lbf }

    2. Connect the 2 hoses with 2 new clips.

  5. CHECK CONNECTIONS OF TUBES FOR AIR LEAK


    1. Check the connections of the tubes for air leakage Click here.

  6. INSTALL REAR BUMPER PROTECTOR SUB-ASSEMBLY LH (for 5 Door)


    1. Install the rear bumper protector with the screw.

  7. INSTALL HEIGHT CONTROL COMPRESSOR COVER


    1. Install the height control compressor cover with 3 new clips.

  8. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH


    1. Install the rear quarter panel mudguard with the 5 screws and 2 clips.

  9. INSTALL REAR WHEEL LH

    Torque:
    112 N*m  { 1142 kgf*cm, 83 ft.*lbf }

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.