SUSPENSION CONTROL SYSTEM (w/ KDSS) ON-VEHICLE INSPECTION


  1. INSPECT VEHICLE HEIGHT

    Note


    • Perform the inspection on a level surface.

    • Make sure that the wheels are on the ground and facing straight ahead.

    • Perform the inspection with the vehicle load completely on the suspension.

    Tech Tips


    • Perform this step with the fuel tank full.

    • If there are any parts installed to the vehicle which place any unbalanced load on the left or right side of the vehicle, remove them.


    1. Set the tire pressure to the specified value(s) Click here.

    2. Bounce the vehicle to stabilize the suspension.

    3. A01DS6I

      Measure the distance from the ground to the top of the bumper and calculate the difference in the vehicle height between the left and right sides. Perform this procedure for both the front and rear wheels.

      Height difference of left and right sides
      20 mm (0.787 in.) or less

      Tech Tips

      When the difference in vehicle height between the left and right sides is outside of the specification, perform air bleeding Click here.

  2. INSPECT FOR SUSPENSION FLUID LEAK

    CAUTION:

    Fluid is pumped into the system at a high pressure of approximately 3 MPa (30.6 kgf/cm2, 435 psi). If a fluid leak is discovered, immediately release the pressure and repair the fluid leak.


    1. Perform a driving test.

    2. Check for fluid leakage from the parts and connections shown in the illustration.

      A01DNPA
      A01DUP8E01