AIR SUSPENSION SYSTEM DTC CHECK / CLEAR


  1. CHECK DTC (When Using Intelligent Tester)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Chassis / Air suspension / DTC.

    5. Read the output DTCs by following the prompts on the intelligent tester screen.

      Tech Tips

      Refer to the intelligent tester operator's manual for further details.

    6. Refer to the Diagnostic Trouble Code Chart for DTC information Click here.

  2. CHECK DTC (When Using SST Check Wire)


    1. Turn the ignition switch off.

    2. A01DTGNE17
      Text in Illustration
      *a Front view of DLC3

      Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040

      Note

      Do not connect the incorrect terminals as this will cause damage.

    3. Turn the ignition switch to ON.

    4. Read the output DTCs from the multi-information display on the combination meter.

    5. Refer to the Diagnostic Trouble Code Chart for DTC information Click here.

  3. CLEAR DTC (When Using Intelligent Tester)

    Tech Tips

    After repairing the malfunctions, clear the DTCs.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Chassis / Air suspension / DTC.

    5. Clear the DTCs by following the prompts on the intelligent tester screen.

      Tech Tips

      Refer to the intelligent tester operator's manual for further details.

  4. CLEAR DTC (When Using SST Check Wire)


    1. Turn the ignition switch off.

    2. A01DTGNE17
      Text in Illustration
      *a Front view of DLC3

      Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040

      Note

      Do not connect the incorrect terminals as this will cause damage.

    3. Turn the ignition switch to ON.

    4. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

    5. Check that no DTCs are output to the multi-information display.

    6. Turn the ignition switch off.

    7. Remove SST from the terminals of the DLC3.

      Note

      As data for other systems may be cleared and DTCs may be stored, be sure to check for DTCs.