Click here

STEERING KNUCKLE REMOVAL

Click here
Click here Click here
Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here
  1. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. Click here

    REMOVE FRONT SPEED SENSOR LH


    1. Remove the bolt and speed sensor from the knuckle.

      Note:

      Pull out the sensor while trying as much as possible not to rotate it.

  3. Click here

    REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH


    1. Remove the front axle hub (Click here).

  4. Click here

    DISCONNECT TIE ROD END SUB-ASSEMBLY LH


    1. A01DPY1E01

      Using SST, disconnect the tie rod end assembly.

      09610-20012
  5. Click here

    DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH


    1. Remove the 2 bolts and disconnect the front lower ball joint attachment from the axle.

  6. Click here

    REMOVE STEERING KNUCKLE LH


    1. Support the front suspension lower arm LH with a jack.

    2. Remove the clip and nut.

    3. A01DMDJE01

      Using SST, disconnect the upper ball joint from the steering knuckle.

      09628-62011
      Note:

      Do not the damage the ball joint dust cover.

    4. Remove the steering knuckle.