FRONT AXLE HUB REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE FRONT WHEEL

  2. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH


    1. A01DM7L

      Using a union nut wrench, disconnect the brake tube from the disc brake cylinder assembly.

      Tech Tips

      Use a container to catch brake fluid as it drains out.

    2. A01DRSV

      Remove the 2 bolts and disc brake cylinder assembly.

  3. REMOVE FRONT DISC


    1. A01DSWKE01
      Text in Illustration
      *1 Matchmark

      Place matchmarks on the disc and axle hub if planning to reuse the disc.

    2. Remove the front disc.

  4. REMOVE FRONT AXLE HUB GREASE CAP


    1. Using a screwdriver and hammer, remove the front axle hub grease cap.

      Note

      Do not damage the axle hub.

  5. REMOVE FRONT AXLE SHAFT NUT


    1. A01DQPJ

      Remove the cotter pin and lock cap.

    2. Remove the front axle shaft nut.

  6. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH

    A01DM98E01

    1. Remove the 4 bolts.

    2. Using a plastic-faced hammer, tap out the front drive shaft from the front axle hub.

      Note

      Be careful not to damage the drive shaft boot.

    3. Remove the front axle hub and front disc dust cover.

    4. Remove the O-ring.