TRANSFER OIL REPLACEMENT


  1. DRAIN TRANSFER OIL

    A01DUI3

    1. Remove the filler plug and gasket.

    2. Remove the drain plug and gasket, and drain the transfer oil.

  2. ADD TRANSFER OIL


    1. Remove the filler plug and gasket.

    2. Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.

      Note


      • Add oil slowly.

      • Add oil a little at a time, waiting several minutes between each addition of oil.

    3. Wait approximately 5 minutes and check that the oil level has not changed.

    4. Install a new gasket to the filler plug and then tighten the plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }