FRONT PROPELLER SHAFT ASSEMBLY DISASSEMBLY


  1. REMOVE FRONT UNIVERSAL JOINT SPIDER BEARING

    Tech Tips

    Use the same procedure for all front propeller shaft universal joint spider bearing.


    1. A01DRC4E10
      Text in Illustration
      *a Matchmark

      Place matchmarks on the flange yoke and sleeve yoke.

    2. A01DQSN

      Using a brass bar and hammer, slightly tap in the spider bearing outer races.

    3. Using 2 screwdrivers, remove the 4 snap rings from the grooves.

    4. A01DN8WE08

      Using SST, remove the spider bearing from the propeller shaft.

      SST
      09332-25010

      Tech Tips

      Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.

    5. A01DNN5E08
      Text in Illustration
      *a Hammering Point

      Clamp the spider bearing outer race in a vise between aluminum plates and tap off the propeller shaft with a hammer.

      Tech Tips

      Remove the bearing on the opposite side using the same procedure.

      Note

      Do not tap the shaft.

    6. A01DTLAE11

      Install the 2 removed spider bearing outer races to the universal joint spider.

    7. Using SST, remove the bearing from the yoke.

      SST
      09332-25010

      Tech Tips

      Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.

    8. A01DODQE09
      Text in Illustration
      *a Hammering Point

      Clamp the outer bearing race in a vise between aluminum plates and tap off the flange yoke with a hammer.

    9. Remove the universal joint spider.