PROPELLER SHAFT ASSEMBLY INSPECTION


  1. INSPECT PROPELLER SHAFT ASSEMBLY


    1. A01DM4G

      Using a dial indicator, check the propeller shaft runout.

      Maximum runout
      for 1KD-FTV, 2TR-FE, 5L-E : 0.3 mm (0.0118 in.)
      for 1GR-FE : 0.4 mm (0.0157 in.)

      If the shaft runout is more than the maximum, replace the propeller shaft.

  2. INSPECT REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING

    Note

    Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.


    1. Check the spider bearings for wear or damage.

      If necessary, replace the spider bearing.

    2. A01DOT0

      Check the spider bearing axial play by turning the yoke while holding the shaft tightly.

      Maximum bearing axial play
      0 mm (0 in.)

      If the axial play is more than the maximum, replace the spider bearing.