PARKING ASSIST ECU (for LHD) INSTALLATION

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL PARKING ASSIST ECU


    1. Install the parking assist ECU with the 2 bolts.

    2. Connect each connector.

  2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    A01DMHCE01
    Text in Illustration
    *1 Bolt
    *2 Screw

    1. Connect each connector.

    2. Attach the 5 clips and claw to install the glove compartment door.

    3. Install the 2 bolts <C> and 2 screws <A> or <B>.

  3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover.

    2. Install the screw.

      A01DNTKE01
      Text in Illustration
      *A for LHD *B for RHD

  4. INSTALL INSTRUMENT PANEL ORNAMENT


    1. Attach the 5 clips to install the instrument panel ornament.

  5. INSTALL INSTRUMENT SIDE PANEL RH


    1. Connect the connector.

    2. Attach the 5 clips, claw and 3 guides to install the instrument side panel.

  6. INSTALL COWL SIDE TRIM BOARD RH


    1. Attach the clip and claw to install the cowl side trim board RH.

    2. Install the clip.

  7. INSTALL DOOR SCUFF PLATE ASSEMBLY RH


    1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate assembly RH.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. CHECK SRS WARNING LIGHT

    Click here.