PARKING ASSIST ECU (for LHD) REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

    A01DQUSE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the door scuff plate assembly RH.

    2. Using a screwdriver, detach the 4 clips, 10 claws and 2 guides and remove the door scuff plate assembly RH.

      Tech Tips

      Tape the screwdriver tip before use.

  4. REMOVE COWL SIDE TRIM BOARD RH

    A01DN9Y

    1. Remove the clip.

    2. Detach the clip and claw and remove the cowl side trim board RH.

  5. REMOVE INSTRUMENT SIDE PANEL RH

    A01DUSZE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument side panel.

    2. Using a moulding remover, detach the 5 clips, claw, and 3 guides.

    3. Disconnect the connector and remove the instrument side panel.

  6. REMOVE INSTRUMENT PANEL ORNAMENT

    A01DQGZE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument panel ornament.

    2. Using a moulding remover, detach the 5 clips and remove the instrument panel ornament.

  7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Remove the screw.

    2. Detach the 3 clips and 2 guides and remove the No. 2 instrument panel under cover.

      A01DNTKE01
      Text in Illustration
      *A for LHD *B for RHD

  8. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    A01DMHCE01
    Text in Illustration
    *1 Bolt
    *2 Screw

    1. Remove the 2 bolts <C> and 2 screws <A> or <B>.

    2. Detach the 5 clips and claw.

    3. Disconnect each connector and remove the glove compartment door.

  9. REMOVE PARKING ASSIST ECU

    A01DOUW

    1. Disconnect each connector.

    2. Remove the 2 bolts and parking assist ECU.