Click here

CLUTCH PEDAL SWITCH INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL CLUTCH START SWITCH ASSEMBLY


    1. for LHD:


      1. Install the clutch start switch assembly with the nut.

        16 N*m 160 kgf*cm 12 ft.*lbf

      2. Connect the clutch start switch connector.

    2. for RHD:


      1. Install the clutch start switch assembly with the nut.

        16 N*m 160 kgf*cm 12 ft.*lbf

      2. Connect the clutch start switch connector and attach the clamp.

  2. Click here

    INSPECT CLUTCH START SWITCH ASSEMBLY


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 - 2 On (Pushed) Below 1 Ω
      1 - 2 Off (Not pushed) 10 kΩ or higher
      Table 1. Text in Illustration
      *a

      Component without harness connected

      (Clutch Start Switch Assembly)
      *b On: 7.65 to 8.35 mm (0.302 to 0.328 in.)
      *c Off: 1.65 to 2.35 mm (0.0650 to 0.0925 in.)

      If the result is not as specified, replace the clutch start switch assembly.