Click here

SPEED SENSOR REMOVAL

Click here
Click here Click here
  1. Click here

    SUPPORT TRANSMISSION AND TRANSFER ASSEMBLY (w/ DPF)


    1. Support the transmission and transfer with a transmission jack.

      Note:

      For safety reasons, install the No. 3 frame crossmember after removing the front exhaust pipe.

  2. Click here

    REMOVE FRONT SUSPENSION MEMBER BRACKET LH AND RH (w/ DPF)


    1. A01DPLV

      Remove the 8 bolts, front suspension member bracket LH and RH.

  3. Click here

    REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY (w/ DPF)


    1. A01DLXZ

      Remove the 4 bolts of the rear engine mounting insulator.

    2. A01DMNM

      Remove the 4 nuts, 4 bolts and frame crossmember.

  4. Click here

    DISCONNECT AIR FUEL RATIO SENSOR (w/ DPF)


    1. A01DM9R

      Disconnect the air fuel ratio sensor connector and detach the clamp.

  5. Click here

    DISCONNECT CENTER EXHAUST PIPE ASSEMBLY (w/ DPF)


    1. A01DT3Z

      Remove the 2 bolts and 2 compression springs, and then disconnect the center exhaust pipe.

  6. Click here

    REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ DPF)


    1. A01DQ0E

      Disconnect the exhaust gas temperature sensor connector.

    2. A01DU6V

      Disconnect the No. 2 exhaust gas temperature sensor connector.

    3. A01DP5C

      Disconnect the No. 3 exhaust gas temperature sensor connector.

    4. A01DSLS

      Disconnect the No. 6 exhaust pipe air hose from the front exhaust pipe.

    5. A01DQQR

      Disconnect the No. 7 exhaust pipe air hose from the front exhaust pipe.

    6. A01DUL9

      Remove the 2 exhaust pipe supports.

      Tip:

      Remove the exhaust pipe supports before removing the No. 3 frame crossmember.

    7. A01DTOS

      Remove the 3 nuts and front exhaust pipe.

    8. Remove the gasket.

  7. Click here

    REMOVE SPEED SENSOR NT


    1. Disconnect the sensor connector.

    2. Remove the bolt and sensor.

    3. Remove the O-ring from the sensor.

  8. Click here

    REMOVE SPEED SENSOR SP2


    1. Disconnect the sensor connector.

    2. Remove the bolt and sensor.

    3. Remove the O-ring from the sensor.