OIL PUMP INSPECTION


  1. INSPECT FRONT OIL PUMP BODY

    A01DSDBE01

    1. Using a dial indicator, measure the inside diameter of the oil pump body bush.

      Maximum inside diameter
      38.19 mm (1.50 in.)

      If the inside diameter is more than the maximum, replace the oil pump body.

  2. INSPECT STATOR SHAFT ASSEMBLY

    A01DPDDE01

    1. Using a dial indicator, measure the inside diameter of the stator shaft bush.

      Maximum Inside Diameter
      Front Side Rear Side
      21.58 mm (0.8496 in.) 27.08 mm (1.0661 in.)

      If the inside diameter is more than the maximum, replace the stator shaft.

  3. INSPECT CLEARANCE OF FRONT OIL PUMP BODY

    A01DMDGE01

    1. Push the driven gear to one side of the body.

    2. Using a feeler gauge, measure the body clearance.

      Standard body clearance
      0.07 to 0.15 mm (0.00276 to 0.00591 in.)
      Maximum body clearance
      0.2 mm (0.00787 in.)

      If the body clearance is more than the maximum, replace the drive gear, driven gear or pump body assembly. Replace the part or parts determined to be the most likely cause of the problem.

    3. A01DTRKE01

      Using a feeler gauge, measure the tip clearance between the driven gear teeth and drive gear teeth.

      Standard tip clearance
      0.004 to 0.248 mm (0.000157 to 0.00976 in.)
      Maximum tip clearance
      0.3 mm (0.0118 in.)

      If the tip clearance is more than the maximum, replace the drive gear, driven gear or pump body assembly. Replace the part or parts determined to be the most likely cause of the problem.

    4. A01DO7BE01

      Using a steel straightedge and feeler gauge, measure the side clearance of both gears.

      Standard side clearance
      0.02 to 0.05 mm (0.000787 to 0.00197 in.)
      Maximum side clearance
      0.1 mm (0.00394 in.)

      If the side clearance is more than the maximum, replace the drive gear, driven gear or pump body assembly. Replace the part or parts determined to be the most likely cause of the problem.

      Tech Tips

      There are 5 different thicknesses for drive and driven gears.

      Drive and Driven Gear Thickness
      Mark Specified Condition
      M 11.690 to 11.699 mm (0.4602 to 0.4606 in.)
      N 11.700 to 11.709 mm (0.4606 to 0.4610 in.)
      P 11.710 to 11.720 mm (0.4610 to 0.4614 in.)
      R 11.721 to 11.730 mm (0.4615 to 0.4618 in.)
      S 11.731 to 11.740 mm (0.4618 to 0.4622 in.)

  4. INSPECT OIL PUMP DRIVE GEAR ROTATION

    A01DU9GE01

    1. Check that the drive gear rotates smoothly.

    2. Remove the oil pump from the torque converter.