TRANSMISSION CONTROL CABLE INSTALLATION


  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Insert the transmission control cable from the vehicle outside, and attach the 3 claws of the cable retainer.

    2. Install the 2 nuts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }
    3. A01DPVX

      Connect the transmission control cable to the shift lever retainer, and install a new clip.

    4. A01DOHVE01
      Text in Illustration
      *1 Ridge

      Connect the control cable end to the shift lever.

      Note

      Make sure to connect the cable end so that the inner cable is not twisted. Confirm that the ridged side of the cable end is facing upward.

    5. Move the shift lever to N.

    6. A01DUBBE01
      Text in Illustration
      *1 Ground Cable

      Connect the transmission control cable support and ground cable with the 2 nuts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }
    7. A01DQYVE01

      Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.

    8. A01DR4SE01

      Connect the transmission control cable to the transmission control cable bracket with a new clip, and connect the cable end to the control shaft lever with the nut.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  2. ADJUST SHIFT LEVER POSITION


    1. Remove the rear console box Click here.

    2. w/ Refrigerated Cool Box:

      Remove the rear console box Click here.

    3. Move the shift lever to N.

    4. A01DNWT

      Loosen the nut of the control cable end.

    5. While pushing the control cable slightly toward the rear side of the vehicle, tighten the nut.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    6. Move the shift lever and check that there is less wobble when moving the shift lever from N to D than when moving the shift lever to P.

    7. Install the rear console box Click here.

    8. w/ Refrigerated Cool Box:

      Install the rear console box Click here.

  3. INSPECT SHIFT LEVER POSITION


    1. When moving the shift lever from P to R with the ignition switch to ON and the brake pedal depressed, make sure that it moves smoothly and correctly into position.

    2. Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to L.

    3. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves in reverse after moving the shift lever to R.

      If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the transmission floor shift assembly installation condition.

      If the indicator and shift lever position do not match, carry out the following adjustment procedures.

  4. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here