CRUISE CONTROL SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

VEHICLE BROUGHT TO WORKSHOP

• NEXT

INSPECT BATTERY VOLTAGE

If the voltage is below 11 V, recharge or replace the battery before proceeding.

• NEXT

CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

1. Use the intelligent tester to check if the CAN communication system is functioning normally.

   Table 1. Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output (for LHD with Entry and Start System)	B
   CAN DTC is output (for LHD without Entry and Start System)	C
   CAN DTC is output (for RHD with Entry and Start System)	D
   CAN DTC is output (for RHD without Entry and Start System)	E

   
   
   • B
   • Go to CAN COMMUNICATION SYSTEM (See pageClick here)
   • C
   • Go to CAN COMMUNICATION SYSTEM (See pageClick here)
   • D
   • Go to CAN COMMUNICATION SYSTEM (See pageClick here)
   • E
   • Go to CAN COMMUNICATION SYSTEM (See pageClick here)
   • A

CHECK FOR DTC*

1. Check for DTCs (Click here).

2. Clear the DTCs (Click here).

3. Recheck for DTCs (Click here).

   Table 2. Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   
   
   • B
   • Go to step 7
   • A

PROBLEM SYMPTOMS TABLE

1. Refer to Problem Symptoms Table (Click here).

   Table 3. Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   
   
   • B
   • Go to step 7
   • A

OVERALL ANALYSIS AND TROUBLESHOOTING*

1. Road Test (Click here)

2. Terminals of ECM (Click here)

3. Data List / Active Test (Click here)

   
   
   • NEXT

ADJUST, REPAIR OR REPLACE

• NEXT

CONFIRMATION TEST

• NEXT
• END