STARTER (for 2.2 kW Type) REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL LH


    1. Remove the 5 clips and frame seal.

  3. REMOVE REAR ENGINE UNDER COVER ASSEMBLY


    1. Remove the 4 bolts and rear engine under cover.

  4. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)


    1. A01DOP9

      Remove the 2 bolts and clip, and then disconnect the release cylinder.

  5. REMOVE STARTER ASSEMBLY


    1. Remove the terminal cap.

    2. A01DMUX

      Remove the nut and disconnect the starter wire.

    3. Disconnect the starter connector.

    4. A01DOP0

      for Automatic Transmission:

      Remove the bolt, 2 nuts and starter assembly.

    5. A01DLTW

      for Manual Transmission:

      Remove the bolt, nut and starter assembly.