STARTER REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH


    1. Remove the exhaust manifold sub-assembly LH Click here.

  3. REMOVE STARTER COVER


    1. A01DO1O

      Remove the 3 bolts and starter cover.

  4. REMOVE STARTER ASSEMBLY


    1. A01DS1M

      Remove the bolt and disconnect the ground wire.

    2. Disconnect the starter connector.

    3. Open the terminal cap.

    4. Remove the nut and bolt, and then disconnect the starter wire.

    5. A01DPDX

      Remove the 2 bolts and starter assembly.

  5. REMOVE FLYWHEEL HOUSING SIDE COVER

    A01DSMG