ENGINE SWITCH (for LHD) REMOVAL


  1. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

    A01DNL5

    1. Detach the 5 clips and remove the No. 2 instrument panel finish panel cushion.

  2. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

    A01DT7H

    1. Detach the 4 clips and remove the instrument panel finish panel end LH.

  3. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION

    Tech Tips

    Use the same procedure described for the No. 2 instrument panel finish panel cushion.

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    A01DPKP

    1. Detach the 4 clips and remove the instrument panel finish panel end RH.

  5. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. A01DQRN

      Detach the 4 clips.

    2. Disconnect the connector and remove the integration control and panel assembly.

  6. REMOVE FRONT CONSOLE UPPER PANEL GARNISH


    1. w/o Seat Heater System:


      1. A01DULFE01
        Text in Illustration
        *1 Protective Tape

        Put protective tape around the front console upper panel garnish.

      2. Detach the 5 clips and remove the front console upper panel garnish.

      3. Disconnect the connector.

    2. w/o CRAWL:


      1. A01DOBAE01
        Text in Illustration
        *1 Protective Tape

        Put protective tape around the front console upper panel garnish.

      2. Detach the 5 clips and remove the front console upper panel garnish.

      3. Disconnect each connector.

    3. w/ CRAWL:


      1. A01DPSBE01
        Text in Illustration
        *1 Protective Tape

        Put protective tape around the front console upper panel garnish.

      2. Detach the 5 clips and remove the front console upper panel garnish.

  7. REMOVE COMBINATION SWITCH (w/ CRAWL)


    1. A01DOBN

      Remove the 2 bolts.

    2. Detach the 3 clamps and remove the center cluster module switch.

    3. Disconnect the connector.

  8. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o CRAWL)


    1. Attach the 3 clips and guide to install the lower center instrument cluster finish panel.

    2. Install the 2 bolts <E>.

  9. REMOVE ENGINE SWITCH


    1. A01DT0U

      Disconnect the connector.

    2. Detach the 2 claws and remove the engine switch.