EXHAUST PIPE INSTALLATION

INSTALL FRONT EXHAUST PIPE ASSEMBLY

1. Install a new gasket and the front exhaust pipe to the exhaust manifold with 3 new nuts.

   54 N*m

   554 kgf*cm

   40 ft.*lbf

2. Install the No. 1 exhaust pipe support bracket with the 2 bolts.

   71 N*m

   724 kgf*cm

   52 ft.*lbf

3. Install the clamp with the bolt.

   19 N*m

   194 kgf*cm

   14 ft.*lbf

INSTALL CENTER EXHAUST PIPE ASSEMBLY

1. 

   Using a vernier caliper, measure the free length of the compression spring.

   Minimum free length
   38.5 mm (1.52 in.)

   
   

   • If the free length is less than the minimum, replace the compression spring.

2. 

   Using a plastic-faced hammer and wooden block, tap on a new gasket until its surface is flush with the front exhaust pipe.

   Table 1. Text in Illustration

   *1	Gasket
   *2	Wooden Block

   Note:
   

   • Be sure to install the gasket so that it is facing in the correct direction.

   • Do not reuse the gasket.

   • Do not damage the gasket.

   • When connecting the exhaust pipe, do not push on the gasket with the exhaust pipe.

3. Connect the center exhaust pipe to the 4 exhaust pipe supports.

4. Install the center exhaust pipe with the 2 compression springs and 2 bolts.

   43 N*m

   438 kgf*cm

   32 ft.*lbf

INSTALL TAILPIPE ASSEMBLY

1. Connect the tailpipe to the exhaust pipe support.

2. Install a new gasket to the center exhaust pipe.

3. Connect the tailpipe to the center exhaust pipe.

4. Install the 2 bolts.

   48 N*m

   489 kgf*cm

   35 ft.*lbf

INSPECT FOR EXHAUST GAS LEAK

• If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.