AIR SWITCHING VALVE (for Bank 1) REMOVAL


  1. REMOVE UPPER RADIATOR SUPPORT SEAL


    1. Remove the 13 clips and upper radiator support seal.

  2. REMOVE V-BANK COVER


    1. A01DQBNE01
      Text in Illustration
      *1 Pin
      *2 Hook

      Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

  3. REMOVE AIR CLEANER CAP AND HOSE


    1. A01DNH7

      Remove the air cleaner cap and hose.


      1. Disconnect the mass air flow meter connector, vacuum hose and ventilation hose and detach the 4 clamps.

      2. Loosen the clamp.

      3. Unfasten the 4 hook clamps, and then remove the bolt and air cleaner cap and hose.

  4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. Remove the air cleaner filter element.

    2. A01DNI3

      Detach the wire harness clamp.

    3. Remove the 3 bolts and air cleaner case.

  5. DISCONNECT WATER HOSE JOINT


    1. A01DM5L

      Remove the bolt and disconnect the water hose joint.

  6. REMOVE AIR TUBE


    1. A01DPZT

      Remove the 2 bolts, 2 nuts and air tube.

    2. Remove the 2 gaskets from the air tube.

      Note

      Be careful not to damage the installation surface of the gaskets.

  7. REMOVE EMISSION CONTROL VALVE SET


    1. A01DMI8

      Disconnect the emission control valve set connector.

    2. Disconnect the No. 1 air hose from the emission control valve set.

    3. A01DMAK

      Remove the 3 nuts and emission control valve set.