FRONT CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. A01DTWJE01

      Apply MP grease to the lip of a new oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. Temporarily install the oil seal to the timing chain cover.

    3. Using SST and a hammer, tap in the oil seal until its surface is flush with the chain cover edge.

      SST
      09223-75010
      09950-70010   ( 09951-07100 )

      Note


      • Keep the lip free from foreign matter.

      • Do not tap the oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. A01DMNYE02
      Text in Illustration
      *a Hold
      A01DQPB Turn

      Align the key groove of the pulley with the pulley set key and slide on the pulley.

    2. Using SST, install a new crankshaft pulley bolt.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021
      Torque:
      260 N*m  { 2651 kgf*cm, 192 ft.*lbf }

      Note

      Do not reuse the pulley bolt.

  3. INSTALL FAN SHROUD


    1. Install the fan pulley to the water pump.

    2. Place the shroud together with the coupling fan between the radiator and engine.

      Note

      Be careful not to damage the radiator core.

    3. Temporarily install the fluid coupling fan to the water pump with the 4 nuts. Tighten the nuts as much as possible by hand.

    4. A01DRX2

      Attach the claws of the shroud to the radiator as shown in the illustration.

    5. Install the shroud with the 2 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    6. Install the fan and generator V-belt Click here.

    7. Tighten the 4 nuts of the fluid coupling fan.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }
    8. A01DS1Z

      Attach the claw to close the flexible hose clamp as shown in the illustration.

  4. INSTALL RADIATOR RESERVOIR


    1. Install the radiator reservoir with the 3 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    2. Connect the reservoir hose to the radiator.

  5. INSTALL UPPER RADIATOR SUPPORT SEAL


    1. Install the upper radiator support seal with the 13 clips.

  6. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.

  7. INSPECT ENGINE OIL LEVEL


    1. Warm up the engine, stop the engine and wait 5 minutes.

    2. Check that the oil level is between the dipstick low level mark and full level mark.

      If the level is low, check for leakage and add oil up to the full level mark.

      Note

      Do not fill engine oil above the full level mark.