REAR CRANKSHAFT OIL SEAL REMOVAL


  1. REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)


    1. Remove the manual transmission Click here.

  2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)


    1. Remove the automatic transmission Click here.

  3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

    A01DRN0E01
    Text in Illustration
    *a Matchmark

    1. Place matchmarks on the clutch cover and flywheel.

    2. Loosen each set bolt one turn at a time until spring tension is released.

    3. Remove the 6 set bolts and pull off the clutch cover.

      Note

      Do not drop the clutch disc.

  4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

    Note

    Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.

  5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


    1. A01DS4JE01

      Using SST, hold the crankshaft pulley.

      SST
      09213-58014
      09330-00021

    2. Remove the 8 bolts and flywheel.

  6. REMOVE PUMP IMPELLER DRIVE PLATE (for Automatic Transmission)


    1. A01DS4JE01

      Using SST, hold the crankshaft pulley.

      SST
      09213-58014
      09330-00021
    2. A01DPUA

      Remove the 8 bolts, the rear drive plate spacer, the pump impeller drive plate and the flywheel and ring gear.

  7. REMOVE REAR CRANKSHAFT OIL SEAL


    1. A01DULIE01
      Text in Illustration
      *1 Cut Position

      Using a knife, cut off the lip of the rear crankshaft oil seal.

    2. Using a screwdriver, pry out the rear crankshaft oil seal.

      Note

      Be careful not to damage the crankshaft.