DRIVE BELT INSTALLATION


  1. INSTALL FAN AND GENERATOR V BELT


    1. Use the pulley set bolt of the tensioner to rotate the tensioner pulley clockwise, and then install the V belt.

      A01DSGFE01
      Text in Illustration
      *1 Crankshaft Pulley *2 Fan Pulley
      *3 Generator *4 No. 2 Idler Pulley
      *5 No. 3 Idler Pulley *6 Cooler Compressor
      *7 Viscous Heater - -
      *a Type A *b Type C
      *c Type B *d Type D

      Note

      Make sure that the V belt is set properly on each pulley.

    2. Check that the indicator mark of the V-ribbed belt tensioner Click here.

  2. INSTALL FRONT HEATER BRACKET (for Cold Area Specification Vehicles)


    1. Install the front heater bracket with the 2 bolts.

      Torque:
      25 N*m  { 250 kgf*cm, 18 ft.*lbf }

  3. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. Install the No. 1 engine under cover with the 4 bolts.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

  4. INSTALL FRONT BUMPER LOWER COVER


    1. Install the front bumper lower cover with the clip and 5 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }