CRANKSHAFT POSITION SENSOR INSTALLATION


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. A01DS8OE03
      Text in Illustration
      *1 O-Ring

      Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

    2. Install the crankshaft position sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Make sure that the O-ring is not cracked or jammed when installing.

    3. Connect the crankshaft position sensor connector and attach the wire harness clamp.

  2. INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET

    Note

    Install the No. 1 compressor mounting bracket exactly as described in the procedures below to properly secure and prevent damage to the fan and generator V belt.


    1. A01DQ1I

      Temporarily install the No. 1 compressor mounting bracket with the 3 bolts.

      Tech Tips

      Temporarily install the No. 1 compressor mounting bracket with the 3 bolts so that the bracket can be moved by hand.

    2. A01DU4EE01
      Text in Illustration
      *a No Clearance
      *b Push
      *c Front

      Push the No. 1 compressor mounting bracket toward the cylinder block as shown in the illustration and tighten bolt B.

      Torque:
      for bolt B
      45 N*m  { 459 kgf*cm, 33 ft.*lbf }

      Tech Tips

      Make sure there is no clearance between the cylinder block and No. 1 compressor mounting bracket as shown in the illustration.

    3. A01DQTZE01

      Uniform tighten the 4 bolts in the order shown in the illustration.

      Torque:
      for bolt A
      45 N*m  { 459 kgf*cm, 33 ft.*lbf }
      for bolt C
      25 N*m  { 250 kgf*cm, 18 ft.*lbf }
      Text in Illustration
      A01DQPB Bolt A
      A01DMKT Bolt C

  3. CONNECT COOLER COMPRESSOR ASSEMBLY


    1. A01DRJ9E01

      Temporarily install the cooler compressor with the 4 bolts.

    2. Tighten the bolts in the order shown in the illustration to connect the cooler compressor.

      Torque:
      25 N*m  { 250 kgf*cm, 18 ft.*lbf }

    3. Connect the connector.

    4. Install the suction hose with the bolt.

      Torque:
      7.8 N*m  { 80 kgf*cm, 69 in.*lbf }

  4. CONNECT VANE PUMP ASSEMBLY


    1. Connect the vane pump with the 2 bolts.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    2. Connect the 2 connectors.

    3. Install the pressure feed tube with the bolt.

      Torque:
      28 N*m  { 285 kgf*cm, 21 ft.*lbf }

  5. INSTALL FAN SHROUD


    1. Install the fan shroud Click here.