SIDE MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

VEHICLE BROUGHT TO WORKSHOP

• NEXT

INSPECT BATTERY VOLTAGE

1. Measure the voltage with the engine switch off.

   Standard voltage
   11 to 14 V

   If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

   
   
   • NEXT

CHECK NAVIGATION SYSTEM OR AUDIO AND VISUAL SYSTEM

1. for Navigation Receiver Type:

   Refer to the navigation system (Click here).

2. for Radio and Display Type:

   Refer to the audio and visual system (Click here).

   Table 1. Result

   Result	Proceed to
   Navigation system or Audio and visual system is normal	A
   Navigation system is abnormal	B
   Audio and visual system is abnormal	C

   
   
   • B
   • GO TO NAVIGATION SYSTEM (See pageClick here)
   • C
   • GO TO AUDIO AND VISUAL SYSTEM (See pageClick here)
   • A

CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

1. Use the GTS to check if the CAN communication system is functioning normally.

   
   

   • for LHD with Entry and Start System:Click here

   • for LHD without Entry and Start System:Click here

   • for RHD with Entry and Start System:Click here

   • for RHD without Entry and Start System:Click here

   Table 2. Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output (for LHD with Entry and Start System)	B
   CAN DTC is output (for LHD without Entry and Start System)	C
   CAN DTC is output (for RHD with Entry and Start System)	D
   CAN DTC is output (for RHD without Entry and Start System)	E

   
   
   • B
   • GO TO CAN COMMUNICATION SYSTEM (See pageClick here)
   • C
   • GO TO CAN COMMUNICATION SYSTEM (See pageClick here)
   • D
   • GO TO CAN COMMUNICATION SYSTEM (See pageClick here)
   • E
   • GO TO CAN COMMUNICATION SYSTEM (See pageClick here)
   • A

CHECK FOR DTC*

1. Check for DTCs and note any codes that are output (Click here).

2. Clear the DTC (Click here).

3. Check for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

   Note:

   The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the side monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.

   System	Proceed to
   Parking Assist Monitor System	Click here
   Wide View Front Monitor System	Click here

   Table 3. Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   
   
   • B
   • Go to step 8
   • A

PROBLEM SYMPTOMS TABLE

1. Refer to the Problem Symptoms Table (Click here).

   Table 4. Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table	A
   Fault is listed in Problem Symptoms Table	B

   
   
   • B
   • ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
   • A

OVERALL ANALYSIS AND TROUBLESHOOTING

1. Terminals of ECU (Click here).

   
   
   • NEXT

ADJUST, REPAIR OR REPLACE

• NEXT

CONFIRMATION TEST

• NEXT
• END