PARKING ASSIST MONITOR SYSTEM (w/o Side Monitor System) DIAGNOSIS SYSTEM


  1. PARKING ASSIST MONITOR DIAGNOSIS SYSTEM


    1. In diagnostic mode for the parking assist monitor system, signals received by the navigation receiver assembly can be checked and the parking assist monitor system can be calibrated, adjusted and checked using the multi-display.

      Note

      Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

      Tech Tips

      The displayed items may differ depending on vehicle specifications.

  2. DIAGNOSIS SCREEN TRANSITION


    1. During parking assist monitor system initialization

      A01DNNYE01
      A01DSAR

    2. After parking assist monitor system initialization

      A01DQEAE01
      A01DNAJ

  3. VEHICLE SIGNAL CHECK

    Tech Tips

    Illustrations may differ from the actual vehicle screen depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle screen.


    1. Start diagnostic mode Click here.

    2. A01DQNJ

      Select "Function Check/Setting" on the "Service Menu" screen to display the "Function Check/ Setting I" screen.

    3. A01DTWW

      Select "Vehicle Signal" on the "Function Check/ Setting I" screen.

    4. A01DUN2

      Vehicle Signal Check Mode


      1. When the "Vehicle Signal Check Mode" screen is displayed, check "REV" the vehicle signal conditions.

        Tech Tips


        • Only conditions having inputs are displayed.

        • This screen displays vehicle signals input to the navigation receiver assembly.

    5. Finish diagnostic mode Click here.

  4. CAR SIGNAL CHECK (parking assist monitor system input signals)


    1. Start diagnostic mode Click here.


      1. A01DQNJ

        Select "Function Check/Setting" on the "Service Menu" screen to display the "Function Check/ Setting I" screen.

      2. A01DTWW

        Select "Camera Setting" on the "Function Check/Setting I" screen.

      3. A01DO8K

        Select "Next" on the "Car Information Check" screen.

        Tech Tips

        After "Next" is selected, the screen transitions differ depending on whether initialization of the parking assist monitor system was performed after the navigation receiver assembly was replaced.

        Parking Assist Monitor System Initialization Screen Transition
        Not performed Car Signal Check screen
        Performed Mode Setting screen
      4. A01DNII

        When the screen changes to the "Mode Setting screen", select "Back Camera Setting" to display the "Car Signal Check" screen.

        Tech Tips

        To select a grayed out item, select and hold the item for 2 seconds or more.

    2. A01DO90

      Car Signal Check


      1. On the "Car Signal Check" screen, it is possible to inspect the state of signals and check the settings.

        Item Inspection Detail Note
        BCTY Back door courtesy switch signal input When "CHK" (red) is displayed, selecting "Next" will not change to the next screen.

        Tech Tips


        • When "CHK" (red) is displayed, perform inspections based on the result of the following inspections.

        • If performing the adjustment after proceeding to the next screen, confirm that all items display "OK" (blue) before selecting "Next".

    3. BCTY inspection

      Tech Tips

      If "CHK" (red) is displayed for "BCTY", check for DTCs and perform troubleshooting based on the output DTCs Click here.

    4. Finish diagnostic mode Click here.

  5. CALIBRATION WHEN SERVICING VEHICLE

    Note

    Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.