Click here

PARKING ASSIST MONITOR SYSTEM (w/ Side Monitor System), Diagnostic DTC:U0073, U0100, U0114, U0126, U0129, U0140

Click here
Click here Click here
DTC Code DTC Name
U0073 Control Module Communication Bus OFF
U0100 Lost Communication with ECM
U0114 Lost Communication with 4WD Control ECU
U0126 Lost Communication with Steering Angle Sensor Module
U0129 Lost Communication with Brake System Control Module
U0140 Lost Communication with Main Body ECU
Click here

DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the parking assist ECU.

Tip:

If CAN communication system DTCs are stored, they may also be stored in other systems.

DTC Code DTC Detection Condition Trouble Area
U0073 Control module communication bus off CAN communication system
U0100 Lost communication with ECM
U0114 Lost Communication with 4WD Control ECU
U0126 Lost communication with steering angle sensor
U0129 Lost communication with skid control ECU (brake actuator assembly)
U0140 Lost communication with main body ECU
Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    CHECK FOR DTC


    1. Clear the DTCs (Click here).

    2. Check for DTCs (Click here).

      Table 1. Result
      Result Proceed to
      DTC U0073, U0100, U0114, U0126, U0129 and U0140 are not output A
      DTC U0073, U0100, U0114, U0126, U0129 or U0140 is output (for LHD with Entry and Start System) B
      DTC U0073, U0100, U0114, U0126, U0129 or U0140 is output (for LHD without Entry and Start System) C
      DTC U0073, U0100, U0114, U0126, U0129 or U0140 is output (for RHD with Entry and Start System) D
      DTC U0073, U0100, U0114, U0126, U0129 or U0140 is output (for RHD without Entry and Start System) E
      Tip:

      • If CAN communication system DTCs are stored, they may also be stored in other systems.

      • If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.

      • If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (Click here).


  2. Click here

    GO TO CAN COMMUNICATION SYSTEMClick here

  3. Click here

    USE SIMULATION METHOD TO CHECKClick here

  4. Click here

    GO TO CAN COMMUNICATION SYSTEMClick here

  5. Click here

    GO TO CAN COMMUNICATION SYSTEMClick here

  6. Click here

    GO TO CAN COMMUNICATION SYSTEMClick here