PARKING ASSIST MONITOR SYSTEM (w/ Side Monitor System), Diagnostic DTC:C1626

DTC Code DTC Name
C1626 Steering Angle Sensor Failure

DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral cable sub-assembly that indicates an internal malfunction.

DTC Code DTC Detection Condition Trouble Area
C1626 A fail flag is transmitted from the steering angle sensor.

  • Spiral cable sub-assembly

  • Parking assist ECU

INSPECTION PROCEDURE

Note


  • When "System initializing" is displayed on the parking assist ECU after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

PROCEDURE


  1. REPLACE SPIRAL CABLE SUB-ASSEMBLY


    1. Replace the spiral cable sub-assembly with a normally functioning one Click here.


    NEXT

  2. CHECK FOR DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      OK
      DTC C1626 is not output.
      Result
      Proceed to Result
      OK A
      NG (for LHD) B
      NG (for RHD) C

    B

    REPLACE PARKING ASSIST ECU Click here

    C

    REPLACE PARKING ASSIST ECU Click here

    A

    END (SPIRAL CABLE SUB-ASSEMBLY IS DEFECTIVE)