PARKING ASSIST MONITOR SYSTEM (w/ Side Monitor System) DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Parking Assist Monitor System / Data List.

    5. Enter the following menus: Body Electrical / Main body / Data List.

    6. According to the display on the GTS, read the Data List.

      Parking Assist Monitor System
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Right Wheel Odometer Info Right wheel odometer information / 0 to 255 0 to 255 Pulse 1 pulse is approximately 2 cm (0.78 in.)
      Left Wheel Odometer Info Left wheel odometer information / 0 to 255 0 to 255 Pulse 1 pulse is approximately 2 cm (0.78 in.)
      FL Wheel Rotative Dir Invalid Front left wheel rotation direction invalid / OK or NG

      OK: Rotation direction normal

      NG: Rotation direction invalid

      		 -
      FR Wheel Rotative Dir Invalid Front right wheel rotation direction invalid / OK or NG

      OK: Rotation direction normal

      NG: Rotation direction invalid

      		 -
      FL Wheel Spd Sensor Battery Front left wheel speed sensor battery / OK or Low

      OK: Sensor battery normal

      Low: Sensor battery malfunctioning

      		 -
      FR Wheel Spd Sensor Battery Front right wheel speed sensor battery / OK or Low

      OK: Sensor battery normal

      Low: Sensor battery malfunctioning

      		 -
      FL Wheel Speed Sensor Front left wheel speed sensor / OK or Op/Shrt

      OK: Sensor normal

      Op/Shrt: Sensor open or shorted

      		 -
      FR Wheel Speed Sensor Front right wheel speed sensor / OK or Op/Shrt

      OK: Sensor normal

      Op/Shrt: Sensor open or shorted

      		 -
      AVC-LAN Master Reset Status AVC-LAN communication condition / OK or NG

      OK: AVC-LAN communication condition is normal

      NG: AVC-LAN communication condition is abnormal

      		 -
      AVC-LAN Master Status AVC-LAN communication condition / OK or NG

      OK: AVC-LAN communication condition is normal

      NG: AVC-LAN communication condition is abnormal

      		 -
      AVC-LAN Connect Status AVC-LAN communication condition / OK or NG

      OK: AVC-LAN communication condition is normal

      NG: AVC-LAN communication condition is abnormal

      		 -
      AVC-LAN Sending Status AVC-LAN communication condition / OK or NG

      OK: AVC-LAN communication condition is normal

      NG: AVC-LAN communication condition is abnormal

      		 -
      AVC-LAN Regist Complete Status AVC-LAN communication condition / OK or NG

      OK: AVC-LAN communication condition is normal

      NG: AVC-LAN communication condition is abnormal

      		 -
      AVC-LAN Regist Request Status AVC-LAN communication condition / OK or NG

      OK: AVC-LAN communication condition is normal

      NG: AVC-LAN communication condition is abnormal

      		 -
      Destination Data Check Verification of Destination Data / OK or NG

      OK: Data Verification Normal

      NG: Data Verification Abnormal

      		 -
      EEPROM Status (Initial read) Parking assist ECU information / OK or NG

      OK: Parking assist ECU is normal

      NG: Parking assist ECU is abnormal

      		 -
      IG Voltage Low Status IG voltage input to parking assist ECU / OK or NG

      OK: IG voltage is normal

      NG: IG voltage is abnormal (too low)

      		 -
      IG Voltage High Status IG voltage input to parking assist ECU / OK or NG

      OK: IG voltage is normal

      NG: IG voltage is abnormal (too high)

      		 -
      ACC Voltage Low Status ACC voltage input to parking assist ECU / OK or NG

      OK: ACC voltage is normal

      NG: ACC voltage is abnormal (too low)

      		 -
      ACC Voltage High Status ACC voltage input to parking assist ECU / OK or NG

      OK: ACC voltage is normal

      NG: ACC voltage is abnormal (too high)

      		 -
      AISIC Output Status Output condition of camera display signal / OK or NG

      OK: Output condition of camera display signal is normal

      NG: Output condition of camera display signal is abnormal

      		 If "NG" is displayed, there is a malfunctions in parking assist ECU.
      Wheel Speed Sensor (4wheel) Effectivity of speed signal from speed signal sensor / OK or NG

      OK: Speed signal is effective

      NG: Speed signal is not effective

      		 -
      Wheel Speed Sensor (Front) Effectivity of speed signal from speed signal sensor / OK or NG

      OK: Speed signal is effective

      NG: Speed signal is not effective

      		 -
      AVC-LAN Output ON Resp Status of the AVC-LAN output on response / OK or Timeout OK or Timeout -
      AVC-LAN Output OFF Resp Status of the AVC-LAN output off response / OK or Timeout OK or Timeout -
      AVC-LAN Start Sound Resp Status of the AVC-LAN start sound response / OK or Timeout OK or Timeout -
      Continuous Bus Off Status of the continuous bus off / Not Detected or Detected OK or Timeout -
      Sending CAN Message Status of the sending CAN message / OK or NG OK or NG -
      ACC Terminal ACC terminal voltage / 0 to 5 0 to 5 V -
      IG Terminal IG terminal voltage / 0 to 5 0 to 5 V -
      Camera Select SW Terminal Wide view front and side camera switch terminal Voltage 0 to 5 V -
      REV Terminal Reverse terminal voltage 0 to 5 V -
      IPA Select SW Terminal IPA select switch terminal voltage 0 to 5 V -
      CS Main SW Terminal Clearance sonar main switch terminal Voltage 0 to 5 V -
      H Sens Signal Output Terminal Height sensor signal output terminal voltage 0 to 5 V -
      H Sens PWR Terminal Height sensor power terminal voltage 0 to 5 V -
      H Sens Signal Input Terminal Height sensor signal input terminal voltage 0 to 5 V -
      Mirror Storage Signal Status of the mirror storage signal / NG or OK

      OK: Status of the mirror storage signal is normal

      NG: Status of the mirror storage signal is abnormal

      		 -
      Back Door Courtesy Signal Status of the back door courtesy light switch signal / NG or OK

      OK: Status of the back door courtesy light switch signal is normal

      NG: Status of the back door courtesy light switch signal is abnormal

      		 -
      R Range Count Reverse range count / 0 to 65535 0 to 65535 Times -
      Shed/Parallel Parking Count Shed/parallel parking count / 0 to 65535 0 to 65535 Times -
      IPA Mode Count IPA mode count / 0 to 65535 0 to 65535 Times -
      Image ASIC Status Status of the image ASIC status / OK or NG

      OK: Status of the image ASIC is normal

      NG: Status of the image ASIC is abnormal

      		 -
      Number of DTC Number of stored trouble codes / min.: 0, max.: 255 Number of DTCs will be displayed -
      Back Camera Synchronization Malfunction Key Cycle Rear television camera synchronization malfunction key cycle / 0 to 65535 0 to 65535 times -
      Back Camera Synchronization Malfunction Key Cycle Elapsed Time Rear television camera synchronization malfunction Key cycle elapsed time / 0 to 1677721.5 0 to 1677721.5 s -
      Front Camera Synchronization Malfunction Key Cycle Front television camera synchronization malfunction key cycle / 0 to 65535 0 to 65535 times -
      Front Camera Synchronization Malfunction Key Cycle Elapsed Time Front television camera synchronization malfunction key cycle elapsed time / 0 to 1677721.5 0 to 1677721.5 s -
      Driver Side Camera Synchronization Malfunction Key Cycle Driver side television camera synchronization malfunction key cycle / 0 to 65535 0 to 65535 times -
      Driver Side Camera Synchronization Malfunction Key Cycle Elapsed Time Driver side television camera synchronization malfunction key cycle elapsed time / 0 to 1677721.5 0 to 1677721.5 s -
      Passenger Side Camera Synchronization Malfunction Key Cycle Passenger side camera synchronization malfunction key cycle / 0 to 65535 0 to 65535 times -
      Passenger Side Camera Synchronization Malfunction Key Cycle Elapsed Time Passenger side camera synchronization malfunction key cycle elapsed time / 0 to 1677721.5 0 to 1677721.5 s -
      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Back Door Courtesy SW Back door courtesy light switch signal / ON or OFF

      ON: Back door open

      OFF: Back door closed

      		 -