Click here

NAVIGATION SYSTEM (for Built-in Memory) Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

Click here
Click here Click here
DTC Code DTC Name
  Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter
Click here

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the H58 navigation receiver assembly connector.

    2. Disconnect the H68 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H58-2 (US1-) - H68-2 (US1-) Always Below 1 Ω
      H58-3 (US1+) - H68-3 (US1+) Always Below 1 Ω
      H58-2 (US1-) - Body ground Always 10 kΩ or higher
      H58-3 (US1+) - Body ground Always 10 kΩ or higher

  2. Click here

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

  3. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR