NAVIGATION SYSTEM (for Built-in Memory) Microphone Circuit between Microphone and Navigation Receiver Assembly

DESCRIPTION

This circuit sends a microphone signal from the telephone microphone assembly to the navigation receiver assembly.

It also supplies power from the navigation receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM

A01DSYUE05

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK NAVIGATION RECEIVER ASSEMBLY


    1. A01DOJ9E16
      Text in Illustration
      *a

      Component with harness connected

      (Navigation Receiver Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H61-19 (MIN-) - Body ground Always Below 1 Ω
      H61-18 (SGND) - Body ground Always Below 1 Ω

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      H61-4 (MACC) - Body ground Engine switch on (ACC) 4.75 to 5.25 V

    NG

    REPLACE NAVIGATION RECEIVER ASSEMBLY Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY)


    1. Disconnect the H61 navigation receiver assembly connector.

    2. Disconnect the W7 roof console box assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H61-4 (MACC) - W7-11 (MACC) Always Below 1 Ω
      H61-5 (MIN+) - W7-12 (MCO+) Always Below 1 Ω
      H61-19 (MIN-) - W7-13 (MCO-) Always Below 1 Ω
      H61-6 (SNS2) - W7-14 (SNS2) Always Below 1 Ω
      H61-4 (MACC) - Body ground Always 10 kΩ or higher
      H61-5 (MIN+) - Body ground Always 10 kΩ or higher
      H61-19 (MIN-) - Body ground Always 10 kΩ or higher
      H61-18 (SGND) - Body ground Always 10 kΩ or higher
      H61-6 (SNS2) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK TELEPHONE MICROPHONE ASSEMBLY


    1. Replace the telephone microphone assembly with a known good one Click here.

    2. Check if the same problem occurs again.

      OK
      Malfunction disappears.

    NG

    REPLACE MAP LIGHT ASSEMBLY Click here

    OK

    END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)