BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:U0100, U0126, U0129, U0142

DTC Code DTC Name
U0100 Lost Communication with ECM / PCM "A"
U0126 Lost Communication with Steering Angle Sensor Module
U0129 Lost Communication with Brake System Control Module
U0142 Lost Communication with Body Control Module "B"

DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor.

Tech Tips

If CAN communication system DTCs are stored, they may also be stored for other systems.

DTC Code DTC Detection Condition Trouble Area
U0100 Lost communication with ECM CAN communication system
U0126 Lost communication with spiral cable sub-assembly
U0129 Lost communication with skid control ECU
U0142 Lost communication with main body ECU (multiplex network body ECU)

INSPECTION PROCEDURE

Note

When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.

PROCEDURE


  1. CHECK DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      Result
      Result Proceed to
      OK (for LHD with Entry and Start System) A
      OK (for LHD without Entry and Start System) B
      OK (for RHD with Entry and Start System) C
      OK (for RHD without Entry and Start System) D
      NG E

      Tech Tips


      • If CAN communication system DTCs are stored, they may also be stored for other systems.

      • If the CAN communication system has been inspected and repaired, the DTCs will not be output when rechecking for DTCs.

      • If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs Click here.


    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    C

    GO TO CAN COMMUNICATION SYSTEM Click here

    D

    GO TO CAN COMMUNICATION SYSTEM Click here

    E

    USE SIMULATION METHOD TO CHECK Click here

    A

    GO TO CAN COMMUNICATION SYSTEM Click here