Click here

TELEVISION CAMERA (for Side) INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL SIDE TELEVISION CAMERA ASSEMBLY


    1. Install the side television camera with the 3 screws.

    2. Connect the connector.

    3. A01DTD1E01

      Attach the claw as shown in the illustration to install the part labeled A to the part labeled B.

      Note:

      Be careful not to break the claw.

    4. A01DNNIE01

      Attach the part labeled C as shown in the illustration.

    5. Install the 5 screws.

    6. Using a T25 "TORX" socket wrench, install the 3 screws.

      Tip:

      • Clean the threads of the screw with non-residue solvent.

      • Apply adhesive to the threads of the screw.

        Adhesive
        Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    7. A01DP9F

      Attach the 8 claws to install the lower cover.

    8. Attach the 4 claws to install the rubber base.

    9. Install the screw.

    10. A01DUMSE02

      Apply 2 new pieces of tape so that they overlap.

      Table 1. Text in Illustration
      *1 Tape
  2. Click here

    INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH


    1. Connect the connector.

    2. Install the light with the 3 screws.

  3. Click here

    INSTALL OUTER MIRROR COVER


    1. Install the outer mirror cover.


      1. A01DOA0E01

        Insert the rib on the outer edge of the cover into the groove of the mirror body.

        Note:

        Do not scratch the turn light.

        Table 2. Text in Illustration
        *1 Rib
      2. A01DQT1E01

        Confirm that the cover and mirror body are aligned properly, and then push the outer end of the cover to attach the outer claws.

        Note:

        • Make sure that the upper ribs of the cover shown in part A of the illustration are properly attached to the mirror body.

        • Make sure that the ribs of the mirror body shown in part B of the illustration are not protruding from the cover.

        Table 3. Text in Illustration
        *1 Rib
      3. A01DMRM

        While making sure that the rib of the cover fits properly into the groove of the mirror body, squeeze the inner end of the cover and the mirror body together to attach the inner claws.

      4. A01DO4S

        Push on the cover at the locations of the 8 claws to confirm that the claws are attached properly.

  4. Click here

    INSTALL OUTER REAR VIEW MIRROR GLASS


    1. Connect the connectors.

    2. A01DQ78

      Attach the 4 claws to install the mirror glass.

  5. Click here

    INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH


    1. Install the outer rear view mirror (Click here).

  6. Click here

    ADJUST SIDE TELEVISION CAMERA ASSEMBLY

    Tip:

    Adjust the side television camera for the passenger side only.


    1. Adjust the side television camera (Click here).