REAR BUMPER REASSEMBLY


  1. INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY


    1. A01HPXD

      Install the rear bumper reinforcement sub-assembly with the 6 nuts.

      Torque:
      61 N*m  { 622 kgf*cm, 45 ft.*lbf }

  2. INSTALL REAR BUMPER ENERGY ABSORBER


    1. A01HNI8

      Engage the 2 guides to install the rear bumper energy absorber.

  3. INSTALL WHEEL HOUSE REINFORCEMENT LH


    1. A01HQYY

      Install the wheel house reinforcement LH with the screw and nut.

    2. Engage the clip.

  4. INSTALL WHEEL HOUSE REINFORCEMENT RH

    Tech Tips

    Use the same procedure as for the LH side.

  5. INSTALL REAR BUMPER SIDE RETAINER LH


    1. A01HPEP

      Engage the 6 claws.

    2. Install the rear bumper side retainer LH with the 3 screws.

  6. INSTALL REAR BUMPER SIDE RETAINER RH

    Tech Tips

    Use the same procedure as for the LH side.

  7. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    1. A01HN2BE01
      Text in Illustration
      *A LH Side
      *B Other Side
      *a Keyhole
      *b Snap

      Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the rear bumper assembly.

      Note


      • Do not damage the front bumper with the protrusion when installing the retainer.

      • Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the front bumper.

      Tech Tips

      When installing the retainer, align the keyhole and snap as shown in the illustration.

  8. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)


    1. A01HNBQE01
      Text in Illustration
      *A LH Side
      *B Other Side

      Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.

      Note

      Push the No. 1 ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.

  9. INSTALL ULTRASONIC SENSOR CLIP (w/ Intuitive Parking Assist System)


    1. A01HQMTE01
      Text in Illustration
      *A LH Side
      *B Other Side

      Engage the 4 claws to install the ultrasonic sensor clip.

    2. A01HQWXE01
      Text in Illustration
      *A LH Side
      *B Other Side

      Engage the clamp.

    3. Connect the connector.

  10. INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ Intuitive Parking Assist System)


    1. A01HPU8

      Connect the 4 connectors.

    2. Engage the 4 clamps to install the No. 2 luggage room wire.