AUTOMATIC LIGHT CONTROL SENSOR INSTALLATION


  1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR


    1. Engage the 2 claws to install the automatic light control sensor.

  2. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY


    1. Connect the connector.

    2. A01HNOW

      Engage the 8 clips to install the No. 1 speaker opening cover assembly.

  3. INSTALL RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Radio Receiver Type)


    1. Connect each connector.

    2. Engage the 8 clips to the vehicle body to temporarily install the radio receiver assembly with air conditioning control assembly.

    3. Install the radio receiver assembly with air conditioning control assembly with the 4 bolts.

  4. INSTALL RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Radio and Display Type)


    1. Connect each connector.

    2. Engage the 8 clips to the vehicle body to temporarily install the radio receiver assembly with air conditioning control assembly.

    3. Install the radio receiver assembly with air conditioning control assembly with the 4 bolts.

  5. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Navigation Receiver Type)


    1. Connect each connector.

    2. Engage the 8 clips to the vehicle body to temporarily install the navigation receiver assembly with air conditioning control assembly.

    3. Install the navigation receiver assembly with air conditioning control assembly with the 4 bolts.

  6. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A01HP6M

      Engage the 6 clips to install the No. 2 instrument panel register assembly.

      Note

      When installing the No. 2 instrument panel register assembly, check that the wire harness is not caught between the No. 2 instrument panel register assembly and duct.

  7. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. Connect the connector.

    2. Engage the clamp.

    3. A01HON9

      Engage the 6 clips and 7 claws to install the center instrument cluster finish panel assembly.

  8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. Connect each connector.

    2. Engage the 4 clips and guide.

    3. Install the upper console panel sub-assembly with the 2 screws <C> or <D>.

  9. INSTALL BOX BOTTOM MAT


    1. Install the box bottom mat.

  10. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for Radio and Display Type with Intuitive Parking Assist System)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for Navigation Receiver Type)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.