COMPRESSOR (for 2GR) DISASSEMBLY


  1. REMOVE COOLER BRACKET


    1. A01HMDI

      Disconnect the connector.

    2. Disengage the clamp.

    3. Remove the screw and cooler bracket.

  2. REMOVE MAGNET CLUTCH ASSEMBLY


    1. A01HQEKE01

      Clamp the cooler compressor in a vise between aluminum plates.

    2. Using SST, hold the magnet clutch hub.

      SST
      07112-76060

    3. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

      Tech Tips

      There is no set number of magnet clutch washers that are used for adjusting clutch clearance.

    4. A01HR07

      Using a snap ring expander, remove the snap ring and magnet clutch rotor.

      Note

      Do not damage the seal cover of the bearing when removing the snap ring.

    5. Disengage the clamp.

    6. A01HPIW

      Using a snap ring expander, remove the snap ring and magnet clutch stator.