COMBINATION METER INSTALLATION


  1. INSTALL COMBINATION METER ASSEMBLY


    1. Connect the 2 connectors.

    2. Engage the wire harness clamp.

    3. Install the combination meter assembly with the 4 screws.

  2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. A01HMZC

      Temporarily install the instrument cluster finish panel assembly as shown in the illustration.

    2. Connect each connector.

    3. Engage the 5 claws, 5 clips and 2 guides, and install the instrument cluster finish panel assembly.

    4. A01HQ0M

      Engage the 2 claws, 4 clips and 2 guides.

  3. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A01HNP2

      Engage the 4 clips to install the No. 1 instrument panel register assembly.

  4. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. A01HNI2

      Engage the 3 clips to install the No. 1 instrument cluster finish panel garnish.

  5. INSTALL INSTRUMENT SIDE PANEL LH


    1. Engage the 3 guides.

    2. A01HOSR

      Engage the 4 claws to install the instrument side panel LH as shown in the illustration.

  6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    1. A01HOOJE01
      Text in Illustration
      *1 Alignment Mark (Yellow)

      Align the alignment mark (Yellow) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.

      Note

      After installation, check that the corners fit correctly.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.