SFI SYSTEM, Diagnostic DTC:P0116

DTC Code DTC Name
P0116 Engine Coolant Temperature Circuit Range / Performance

DESCRIPTION

Refer to DTC P0115 Click here.

DTC No. DTC Detection Condition Trouble Area
P0116

The engine coolant temperature is between -40 and 60°C (-40 and 140°F) when the engine is started and conditions (a) and (b) are met (2-trip detection logic):


  • (a) The vehicle is driven at varying speeds (accelerated and decelerated).

  • (b) The engine coolant temperature remains within 3°C (5.4°F) of the initial engine coolant temperature.

  • Thermostat

  • Engine coolant temperature sensor

INSPECTION PROCEDURE

Tech Tips


  • If DTC P0115, P0117 or P0118 is output simultaneously with DTC P0116, the engine coolant temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.


  • Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE


  1. CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON and turn the tester on.

    3. Enter the following menus: Powertrain / Engine and ECT / DTC.

    4. Read the DTCs.

      Result
      Result Proceed to
      DTC P0116 is output A
      DTC P0116 and other DTCs are output B

      Tech Tips

      If any DTCs other than P0116 are output, troubleshoot those DTCs first.


    B

    GO TO DTC CHART Click here

    A

  2. INSPECT THERMOSTAT


    1. Inspect the thermostat Click here.


    NG

    REPLACE THERMOSTAT Click here

    OK

    REPLACE ENGINE COOLANT TEMPERATURE SENSOR Click here