ENGINE IMMOBILISER SYSTEM (w/ Smart Key System) DIAGNOSTIC TROUBLE CODE CHART
Tech Tips
If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.
| DTC Code | Detection Item | Detection Enabling Condition (DTC Output Confirmation Operation) | See page |
|---|---|---|---|
| B2784 | Antenna Coil Open / Short | With the shift lever in P, the key is held near the engine switch and an engine start operation is performed by pressing and holding the engine switch when the key battery is depleted. | |
| B278A | Short to GND in Immobiliser System Power Source Circuit | With the shift lever in P, the key is held near the engine switch and an engine start operation is performed by pressing and holding the engine switch when the key battery is depleted. | |
| B278D | Malfunction of ID-BOX Recognition | Always |
| DTC Code | Detection Item | Detection Enabling Condition (DTC Output Confirmation Operation) | See page |
|---|---|---|---|
| B2799 | Engine Immobiliser System Malfunction | Either condition is met: - Within 10 seconds of an engine start operation being performed (with the shift lever in P and the brake pedal depressed, the engine switch is pressed while carrying the key). If there is a malfunction, the engine stops (communication begins within 3 seconds of the engine start operation being performed, and DTCs are stored after 6 seconds). - 10 seconds after the engine switch is turned on (IG) after reconnecting the cable to the negative (-) battery terminal (communication begins within 3 seconds of the engine switch being turned on (IG), and DTCs are stored after 6 seconds). |
|
| B279A | Theft Deterrent System Communication Line High Fixation | Turn the engine switch on (IG) and wait 6 seconds. | |
| B279C | Theft Deterrent System Presence Detection | Check for DTCs. |