SAFETY CONNECT SYSTEM DCM POWER SOURCE CIRCUIT

DESCRIPTION

This is the power source circuit to operate the DCM (Telematics Transceiver).

WIRING DIAGRAM

A01HNNBE05

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (DCM (TELEMATICS TRANSCEIVER) - BATTERY AND GROUND)


    1. A01HP7LE51
      Text in Illustration
      *a

      Front view of wire harness connector

      (to DCM (Telematics Transceiver))

      Disconnect the I135 DCM (Telematics Transceiver) connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I135-4 (E) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      I135-1 (+B) - I135-4 (E) Always 11 to 14 V
      I135-7 (IG2) - I135-4 (E) Engine switch on (IG) 11 to 14 V
      I135-8 (ACC) - I135-4 (E) Engine switch on (ACC) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here