SAFETY CONNECT SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the Techstream to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the Techstream on.

    4. Enter the following menus: Body Electrical / Telematics / Data List.

    5. According to the display on the Techstream, read the "Data List".

      Telematics
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Emergency Switch Manual (SOS) switch / OFF or ON OFF: Manual (SOS) switch not pressed -
      ON: Manual (SOS) switch pressed -
      Current Com Back-Up Battery BUB (Back-Up Battery) installation history / with or without with: BUB (Back-Up Battery) was connected at some point (does not guarantee that BUB (Back-Up Battery) is currently connected) -
      without: This DCM (telematics transceiver) has no record of a BUB (Back-Up Battery) ever being connected -