NAVIGATION SYSTEM AVC-LAN Circuit

DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers switch signals through the AVC-LAN.

If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT NAVIGATION RECEIVER ASSEMBLY

   
   
   1. 

      Text in Illustration

      *a	Component without harness connected (Navigation Receiver Assembly)

      Remove the navigation receiver assembly Click here.

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 7 (TX1+) - 8 (TX1-) Always 60 to 80 Ω

   
   

   NG

   REPLACE NAVIGATION RECEIVER ASSEMBLY Click here

   OK

2. CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)

   
   

   1. Disconnect the I8 navigation receiver assembly connector.

   2. Disconnect the I69 stereo component amplifier assembly connector.

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition I69-8 (TX+) - I8-7 (TX1+) Always Below 1 Ω I69-7 (TX-) - I8-8 (TX1-) Always Below 1 Ω I69-8 (TX+) - Body ground Always 10 kΩ or higher I69-7 (TX-) - Body ground Always 10 kΩ or higher

   
   

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR

   OK

3. INSPECT MALFUNCTIONING PARTS

   
   

   1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

      Tech Tips

      
      

      • Check all slave units.

      • If disconnecting a slave unit causes the master unit to return to normal operation, the slave unit is defective and should be replaced.

      OK
      Master unit returns to normal operation.

   
   

   NG

   REPLACE NAVIGATION RECEIVER ASSEMBLY Click here

   OK

   REPLACE MALFUNCTIONING PARTS