INSTRUMENT PANEL SPEAKER INSTALLATION


  1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY


    1. Connect the connector.

    2. A01HP58E01
      Text in Illustration
      *A LH Side
      *B RH Side

      Install the front No. 2 speaker assembly with the 2 screws.

      Note

      Do not touch the speaker cone.

      Tech Tips

      Install the screws in the order shown in the illustration.

  2. INSTALL INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    1. A01HPHP

      Engage the 2 guides.

    2. Engage the 3 claws and 2 clips to install the No. 1 instrument panel speaker panel sub-assembly.

  3. INSTALL FRONT PILLAR GARNISH


    1. Remove the protective cover.

    2. Make sure that the front pillar garnish clip is not damaged.

      Note

      If there is any damage, replace the garnish clip with a new one.

    3. A01HR11

      Install the front pillar garnish clip to front pillar garnish LH.

      Tech Tips

      Install the front pillar garnish clip so that it faces as shown in the illustration.

    4. Engage the 2 guides as shown in the illustration.

    5. A01HQ86

      Engage the 2 clips to install the front pillar garnish LH.

  4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

    for LH side: Click here

    for RH side: Click here

  5. INSTALL FRONT NO. 3 SPEAKER ASSEMBLY (for 10 Speakers)


    1. Connect the connector.

    2. A01HPOUE01

      Install the front No. 3 speaker assembly with the 2 screws.

      Note

      Do not touch the speaker cone.

      Tech Tips

      Install the screws in the order shown in the illustration.

  6. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY (for 10 Speakers)


    1. Connect the connector.

    2. A01HNOW

      Engage the 8 clips to install the No. 1 speaker opening cover assembly.

  7. INSTALL RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for 10 Speakers)

    for Radio and Display Receiver Type: Click here

  8. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for 10 Speakers)

    for Navigation Receiver Type: Click here

  9. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for 10 Speakers)


    1. A01HP6M

      Engage the 6 clips to install the No. 2 instrument panel register assembly.

      Note

      When installing the No. 2 instrument panel register assembly, check that the wire harness is not caught between the No. 2 instrument panel register assembly and duct.

  10. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for 10 Speakers)


    1. Connect the connector.

    2. Engage the clamp.

    3. A01HON9

      Engage the 6 clips and 7 claws to install the center instrument cluster finish panel assembly.

  11. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for 10 Speakers)


    1. Connect each connector.

    2. Engage the 4 clips and guide.

    3. Install the upper console panel sub-assembly with the 2 screws <C> or <D>.

  12. INSTALL BOX BOTTOM MAT (for 10 Speakers)


    1. Install the box bottom mat.

  13. INSTALL REAR CONSOLE BOX ASSEMBLY (for 10 Speakers)

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for 10 Speakers)

    Note

    except Radio and Display Type without Intuitive Parking Assist System:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.