AUDIO AND VISUAL SYSTEM (for Radio and Display Type with Intuitive Parking Assist System) Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier

DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.

If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.

If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM

A01HNZQE18

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    1. A01HMWAE02
      Text in Illustration
      *a

      Component with harness connected

      (Stereo Component Amplifier Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      I69-1 (MUTE) - Body ground

      Ignition switch ACC, audio system playing

      → Changing modes

      Above 3.5 V

      → Below 1 V

    NG

    CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) Click here

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

  2. CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)


    1. Disconnect the navigation ECU sub-assembly connector.

    2. Disconnect the stereo component amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I67-20 (MUT2) - I69-1 (MUTE) Always Below 1 Ω
      I67-20 (MUT2) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL)


    1. Reconnect the stereo component amplifier assembly connector.

    2. A01HN1TE05
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Navigation ECU Sub-assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      I67-20 (MUT2) - Body ground Ignition switch ACC, audio system is playing Above 3.5 V

    NG

    REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY Click here

    OK

    REPLACE NAVIGATION ECU SUB-ASSEMBLY Click here