VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1432

DTC Code DTC Name
C1432 Steering Angle Sensor Power Source Voltage Malfunction

DESCRIPTION

This DTC is stored when the skid control ECU receives a +B line open signal from the steering angle sensor.

DTC No. DTC Detection Condition Trouble Area
C1432 With the +BS terminal voltage 9.6 to 16.5 V, the steering angle sensor power supply circuit malfunction signal is received from the steering angle sensor.

  • Steering angle sensor power supply

  • Steering angle sensor

WIRING DIAGRAM

Refer to DTC C1434 Click here.

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)


    1. A01HMLIE40
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Steering Angle Sensor)

      Remove the steering wheel and the column cover.

    2. Make sure that there is no looseness at the locking part and the connecting part of the connector.

    3. Disconnect the steering angle sensor connector.

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      I29-5 (BAT) - Body ground Always 11 to 14 V
      I29-4 (IG) - Body ground Ignition switch ON 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)

    OK

  2. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)


    1. A01HMLIE41
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Steering Angle Sensor)

      Turn the ignition switch off.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I29-1 (ESS) - Body ground Always Below 1 Ω

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts Click here.


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)

    OK

    REPLACE STEERING ANGLE SENSOR Click here